ok so in the bios screen for adjusting your fsb and multiplier, it should go like this, turn off dynamic overclocking, turn off cool n quiet mode, enable dram clock and lower it to ddr 333, set the cpu multiplier to 6x and then set the fsb to 200, then check to see if it boots, while it is booting take note of the processor speed. It should show 1200mhz or 2000+ or something like that, once you test that it will load and work try stepping up the multiplier to 7x. Repeat the boot test, note the processor speed and post the results here. When you get to 8x with successfull boot and testing, try upping the FSB from 200 to 210 and retest it. note the cpu speed listed when it is booting, test the performance out, if it is stable try going to 220. to get 2.4 ghz you will need 240fsb and 10x multiplier.